ROAMEO is a wireless matrix system from RTS. In this Application Note, we will look at a way of connecting the ROAMEO Access Points using Power over Ethernet, PoE.
Power over Ethernet is a way of simplifying wiring for devices that connect to Ethernet. With PoE, there is no need for a separate power supply. There is an upper limit on the amount of power that can be supplied using PoE, and the limit is dependent on the type of PoE switch used. In general, PoE is intended for devices that require little power, up to about 13 Watts. (There is another standard called PoE Plus, which allows up to 25 Watts of power, but we will not get into that here.) With PoE, the data signal is superimposed on the power. On the receiving end, filters are used to pick out the data from the power. When a PoE device is turned on, it communicates with the PoE switch to “negotiate” the right electrical parameters. For this reason, PoE devices can never be connected in cascade.
The ROAMEO Access Point, AP-1800, is designed to be tolerant to PoE, but it is not designed to use PoE directly. Expressed differently, it is PoE tolerant but not PoE enabled. RTS does supply a PoE adapter kit, to allow the AP-1800 to work with a PoE enabled switch. The PoE kit is shown in Figure 1.
The kit can be ordered as any other part. The part number is F.01U.335.167 (POE ADAPTER 12V) and it contains the following parts:
The ROAMEO Access Point is designed to be powered by 12 VDC. Set the Voltage selector on the PoE adapter to 12V. If the PoE adapter is set to a lower Voltage, e.g., 5 or 9 V, nothing will break, but the access point may not work correctly, even though it may seem to power up. See switch location in Figure 2.
Once the voltage has been set to 12 V as described in the previous section, the cable from the PoE switch is connected to the rear of the PoE adapter, and the signal output and DC connectors are connected to the AP1800. Note you must use the barrel adapter to make a reliable electrical connection between the cable and the AP-1800. Without the barrel connector, it will not work.
We will now look at some ways in which the PoE-enabled Access Point can be connected to the system. To symbolize a PoE-enabled Access Point, we will use the symbol shown in Figure 4.
In the first example, we will show how a single AP-1800 may be connected. Note the PoE-enabled AP-1800 on the right is connected directly to the switch. The other two APs are running on local power (meaning they are connected to power using the supplied AC to DC converter). The first AP is connected to PoE, but is not utilizing that power.
In the second example, another AP is connected to the PoE-enabled AP. The second AP must have local power. The OMNEO signal coming out of the second Ethernet jack on the PoE-enabled AP no longer has power.
ROAMEO Access Points can work with PoE, but they require an adapter, which must be purchased separately (e.g., it is not included). Each AP that requires PoE must be connected directly to a PoE switch. The total power of all PoE enabled APs must not exceed the total power of the PoE switch.